73Communicating with a Specific Remote StationUsing the Tone Squelch FunctionNotification of Call from the Remote Station by Vibration of theVibratorCall from the remote station (reception of a signal containing a coincident tone or DCS)can be notified by the vibrator.1 Press the M key more than 1 second.The Set mode is selected.2 Turn the O knob to select “7 CONFIG”.3 Press the M key briefly.4 Turn the O knob to select “22 VIBRATOR”.5 Press the M key briefly.6 Turn the A knob to select “MODE”.7 Turn the O knob to select “SIGNALING”.8 Press the M key more than 1 second.The vibrator function is activated.9 Press the O key more than 1 second again.The Set mode is canceled.Hints To turn off the vibrator function, select “OFF” in step 6.Hints• The vibrator function can be set for all frequency bands belonging to A- and B-bands.• Selecting “7 CONFIG” “23 VIBRATOR” “BUSY” in the Setmode will cause the vibrator to start vibrating when the BUSY LEDlights upon receipt of a signal. A solid line () is displayed underthe mode indication on the LCD.• If you operate a key while the vibrator is vibrating, the vibratorstops vibrating and enters the suspended state. In this case, thedashed line (----) or solid line () on the LCD blinks.If the BUSY state is not held continuously more than 5 seconds, the suspended state is canceled.• If the p switch is operated to change the communication mode from transmission to receptionwhen the vibrator is turned ON, the vibrator function is turned off for 5 seconds and the dashed line(----) or solid line () on the LCD blinks.Selecting a Vibrator Operation Mode1 Press the M key more than 1 second.The Set mode is selected.2 Turn the O knob to select “7 CONFIG”.3 Press the M key briefly.4 Turn the O knob to select “22 VIBRATOR MODE”.5 Press the M key briefly.6 Turn the A knob to select “SELECT”.