76Communicating with a Specific Remote StationUsing the Tone Squelch FunctionFlow of Operation to Use the Pager FunctionSet the same code as that of the remote station.Determine a frequency.Perform transmission/reception.Confirm reception according to the informationon the LCD and the bell soundSetting the Code of Your StationSet the “personal code (your code)” used to be called by other stations.1 Press the M key more than 1 second.The Set mode is selected.2 Turn the O knob to select “4 SIGNALING”.3 Press the M key briefly.4 Turn the O knob to select “6 PAGER”.5 Press the M key briefly.6 Turn the A knob to select “CODE-RX”.7 Turn the O knob to select a code.Select the first code from among 1-50.8 Press the B key briefly.The cursor “” moves.9 Turn the O knob to select a code.Select the second code from among 1-50.Precaution The second code must be different from the first code.10 Press the M key more than 1 second.The code of your station is determined.11 Press the M key more than 1 second again.Hints • Default: “05 47”• The first and second codes contained in your personal code may be inverted, i.e., “05 47”and “47 05” are recognized as being the same code.• If the same personal code (group code) is specified for all persons, all persons can be calledat the same time.