55Scanning FunctionUsing the Scanning FunctionMemory Bank Link ScanDuring regular memory bank scanning, only thememory channels assigned to the recalled memorybank are scanned. During memory bank linkscanning, memory channels registered in two or morepreviously specified banks can be scanned.1 Press the V key.The Memory mode is selected.2 Press the B key briefly.Recall a memory bank.3 Press the F key briefly, and then press the B key briefly.4 Turn the O knob to select a memory bank.Select a memory bank subject to bank link scanning.5 Press the V key briefly.Select the bank link.The memory bank number changes from “B” to “b”,indicating that the bank link has been activated6 Repeat steps 2-4 to select another memory bank.Hints For the scanning range to be specified, see the table on page66.7 Press the B key briefly.The memory banks subject to memory bank scanning are determined.8 While pressing the B key, specify a scanning range.Hints For the scanning range to be specified, see the table on page 66.9 Release the B key.Scanning (SCAN) is performed toward higher memory channel numbers.Hints • Turn the O knob clockwise.:Scanning is performed toward higher memory channel numbers.Turn the O knob counterclockwise.:Scanning is performed toward lower memory channel numbers.• When a signal is received during scanning, scanning stops for 5 seconds and this frequencyis received.• When scanning is suspended, the decimal point blinks and the LCD stays lit.• After receiving the frequency for 5 seconds, scanning resumes.• To cancel scanning, press the p switch. Canceling Bank Link Scanning1 Press the F key briefly, and then press the B key briefly.2 Recall the link for which bank link scanning was specified.3 Press the V key briefly.The memory bank number changes from “b” to “B”, indicating that the bank link hasbeen deactivated.BANK 1 BANK 10BANK 24The memory bank numberchange from “B” to “b”.
