72Communicating with a Specific Remote StationUsing the Tone Squelch Function8 Press the M key more than 1 second.The selected DCS code is determined.9 Press the M key more than 1 second.The Set mode is canceled.Hint• By default, the DCS code is set to “023”.Searching for the Frequency of the DCS Used by the Remote StationThe DCS code used by the remote station can be searched for and displayed.1 Press the M key more than 1 second.The Set mode is selected.2 Turn the O knob to select “4 SIGNALING”.3 Press the M key briefly.4 Turn the O knob to select “11 SQL TYPE”.5 Press the M key briefly.6 Turn the O knob to select “DCS”.7 Press the M key briefly.The selected DCS is determined.8 Turn the O knob to select “2 DCS CODE”.9 Press the M key briefly.10 Receive the signal from the remote station.11 Press the B key more than about 1 second.“DCS SEARCH” is displayed.12 Release the B key.Search for the DCS code starts.When a coincident DCS code is found, a beep is emitted and search stopstemporarily. The found DCS code blinks.Hints To set the found DCS code, use the following procedure:Press the B key. A beep is emitted. Press the M key more than 1 second. Press the M key more than 1 second again.The Set mode is canceled.HintFor the operation to perform when scan stops, refer to “Selecting a Reception Method WhenScanning Stops” (See page 57).