78Communicating with a Specific Remote StationUsing the Tone Squelch Function16 Press the M key more than 1 second.The code is determined.17 Press the M key more than 1 second again.The Set mode is canceled.18 Press the p key.Call the remote station.Being Called by the Remote Station (Standby Operation)If you use the new pager function at the same frequency as that of the remote station,“PAG” displayed on the LCD changes to “PIN”, allowing you to check that you havebeen called by the remote station. In addition, if you turn on the “bell function (See page140)”, you can confirm call by the remote station by the “PAG” display, the blinking bicon, and the bell sound. In addition, if you turn on the “vibrator function (See page 139),you can confirm call by the remote station by vibration of the vibrator.HintSelecting “4 SIGNALING” “9 PAGER ANS-BACK” “ON” in the Set mode places the FT1DR inthe transmission state (for about 2.5 seconds) automatically when called by the remote party andnotifies the remote party of getting ready for communication.
