48Scanning FunctionScanning FunctionUsing the Scanning FunctionThe FT-1DR supports the following four scan modes:(1) VFO Scan(2) Memory Scan(3) Programmable Memory Scan(4) Selected Memory Channel ScanVFO Scan1 Select the VFO mode, and then select a band to scan.2 While pressing the B key, turn the O knob to specify the scanning range.Specify the scanning range as follows.Display* OperationALL Scans all bands within the range from the current frequency to 108-999 MHz.(PMSnumber)Shortcuts the PMS scanning procedure (steps 1 and 2 described on page 46).If PMS memories have been registered in advance, PMS memory numbers aredisplayed. Turn the O knob to select the PMS memory you want to scan, and thenscan the PMS range.± 1 MHz Scans the current band (see the table on the next page) within ± 1 MHz of thecurrent frequency.± 2 MHz Scans the current band (see the table on the next page) within ± 2 MHz of thecurrent frequency.± 5 MHz Scans the current band (see the table on the next page) within ± 5 MHz of thecurrent frequency.BAND Scans the current band (see the table on the next page) starting with the currentfrequency.3 Release the B key.Scanning (SCAN) starts toward higher frequencies.Hints While the B key is pressed down, the scanning range is displayed on the LCD.When a signal is received during scanning, the decimal point blinks.Turn the O knob clockwise.: Scanning is performed toward higher frequencies.Turn the O knob counterclockwise.: Scanning is performed toward lower frequencies.When a signal is received during scanning, a beep is emitted and its frequency is displayedfor 5 seconds. When scanning is suspended, the decimal point blinks and the LCD stays lit.After receiving the signal for 5 seconds, scanning resumes.PrecautionThe difference between the upper limit frequency and the lower limit frequency for PMS must be 100kHz or more.