11• The reverse combination works as the same code, that is “05 47” is the same as “47 05”.• If the same code is specified for all individuals, all the individuals can be called at the sametime.• The default code is “05 47”.• When receiving the signals, the intermittent sound of the tone signal may be heard slightly.Calling a Specific StationThe “pager code” may be set to call specific stations.1. Activate the pager function by referring to “Using the Pager Function” (page 10).2. Touch [F MW] [CODE].If [CODE] is not displayed, touch [FWD →] to display [CODE] and then touch it.3. Rotate the DIAL knob to select “CODE-TX”.4. Press the [DISP] key to move the “u” icon to the first element of the code.Rotate the DIAL knob to select the first element of the code from 1 to 50.5. Press the [DISP] key to move the “u” icon to the second element of the code.Rotate the DIAL knob to select the second element of the code from 1 to 50.The same code cannot be use for both elements.6. Press the PTT switch to save the setting and return to normal operation.7. Press the PTT switch to transmit a call to the specific station.Receiving “pager code” calls from a Remote Station (Standby Operation)When the Pager function is activated, and a call is received with a corresponding Code,the audio is heard. When the PTT switch is pressed, the “ ” icon blinks and the otherstation's audio is heard regardless of whether the code matches or not. About 10 sec-onds after the signal disappears, the “ ” icon will light, and the sound of the un-matched signal will not be heard.Furthermore, when the Bell function (see below) is activated, the bell rings and the “ ”icon blinks when receiving calls from the other station.Using the Pager Answer Backwhen called by another station with a corresponding pager code, the transceiver is auto-matically placed in the transmit mode (for about 2.5 seconds) to notify the other stationthat you are ready to communicate.1. Activate the pager function by referring to “Using the Pager Function” (page 10).2. Touch [F MW] [CODE].If [CODE] is not displayed, touch [FWD →] to display [CODE] and then touch it.3. Press the [DISP] key, and then rotate the DIAL knobto select “ON”. 6 PAGERANS-BACK: ONCODE-RX : 05 47CODE-TX : 05 474. Press the PTT switch to transmit a call to the specific station.