9Setting the DCS CODE1. Touch [F MW] [SQTYP].If [SQTYP] is not displayed, touch [FWD →] to display [SQTYP] and then touch it.2. Rotate the DIAL knob to select “DCS”.3. Press the PTT switch to save the setting and return to normal operation.4. Touch [F MW] [CODE].5. Rotate the DIAL knob to select the DCS code.6. Press the [BACK] key to save the detected tonefrequency and return to normal operation.2 DCS CODEDCS : 023• The DCS code set by the above operation is the common setting for all transmissions witha DCS Code (DCS, D CODE, T DCS, D TONE).• The default DCS code is “023”.Searching for the DCS Code Used by the Other StationSearch for the DCS code used by the other station.1. Touch [F MW] [SQTYP].If [SQTYP] is not displayed, touch [FWD →] to display [SQTYP] and then touch it.2. Rotate the DIAL knob to select “DCS”.3. Press the PTT switch to save the setting and return to normal operation.4. Touch [F MW] [CODE].The DCS code setting screen is displayed.5. Touch [SEARCH].• The transceiver starts to search for the DCS code.• When a corresponding DCS code is detected, abeep sound is emitted. The detected DCS codeblinks. The searching stops for 5 seconds and theaudio is heard.2 DCS CODEDCS : 0236. Touch [STOP] to stop searching.7. Press the [BACK] key to save the detected DCS code and return to normaloperation.To set the transceiver operation when scanning stops, press and hold the [DISP] key [SCAN] [4 SCAN RESUME]. This setting is common for all scan settings, the tone searchfunction and DCS search function.