Yaesu FT3DR Advanced Manual
Also see for FT3DE: Operating manualManualInstruction manualInstruction manualOperating manual
                                             | |
Contents
|
42Clone OperationData and various settings saved in your transceiver can be copied to any other FT3DR/DE transceiver.DATA terminal DATA terminal1. Turn OFF the power of both FT3DR/DE transceivers, then connect an optional clonecable (CT-168) to the DATA terminal of each transceiver.2. While pressing and holding the [DISP] keys on both FT3DR/DE transceivers, pressthe POWER switch.The two transceivers are turned on and placed in the clone mode. The “CLONE” ap-pears on the display.3. Touch [RECEIVE] on the receiving side transceiver.The “WAIT” appears on the display.4. Touch [SEND] on the transmitting side transceiver.• The “TX” appears on the display and data transfer starts.• When data transfer starts, the display on the receiving transceiver changes from“WAIT” to “RX”.• When data transfer begins, the data transfer amount indicator appears on theLCD.5. When copying is completed, the receiving side transceiver returns to the normalmode. On the transmission side transceiver, the indication on the LCD returns from“TX” to “CLONE”.6. Turn OFF the power of both transceivers, then disconnect the clone cable.• When the “ERROR” appears on the LCD during data transfer, copying cannot becompleted. Check the clone cable connection, and redo the operation from thebeginning.• Time data cannot be copied. |
Related manuals for Yaesu FT3DE
manualsdatabase
Your AI-powered manual search engine