Yamaha AV-XS80 Owner's Manual

Also see for AVX-S80: Owner's manual

25BASIC PLAYBACKEnglishUSING BASIC FUNCTIONS SILENT CINEMA DSPYou can enjoy a powerful sound field similar to what youcould expert from actual speakers with SILENTCINEMA DSP. You can listen to SILENT CINEMA DSPby connecting your headphones to the PHONES (SILENT) jack while the digital sound field processor ison. Enjoy all the DSP program using the headphones. The“SILENT” indicator lights up on the front panel display.(When sound effects are off, you listen to the source withnormal stereo reproduction.)y• When SILENT CINEMA DSP is functioning, the “SILENT”indicator lights up on the front panel display.Notes• This feature is not available when 96-kHz sampling digitalsignals are input to this system.• The sound of LFE channel will be mixed and output from theheadphone. Normal Stereo ReproductionPress STEREO to turn off the sound effect for normalstereo reproduction.Press STEREO again to turn the sound effect back on.Notes• If you turn off the sound effects, no sound is output from thecenter or rear speakers.• The volume may be greatly reduced when you turn off thesound effects or if you set “4 D. RANGE” on the SET MENUto MIN. In this case turn on the sound effect.• The sound of LFE channel will be directed to the front left andright or the subwoofer (or both) channels depending on thesetting of “1D BASS” on the SET MENU.• If you turn off the sound effects while a Dolby Digital or DTSsignal is being output, the dynamic range of the signal isautomatically compressed and the sounds of the center and rearspeaker channels are mixed and output from the front speakers. Displaying the information aboutinput signalDuring stereo reproduction, you can display information such asthe type, format and sampling frequency of the signal input fromthe components connected to this system.(While playing a stereo source)1 Press AMP.2 Press d to display the information about theinput signal.y• Format:The type of an input signal. When digital input is not known,the mode is set to the analog mode.• fs :The sampling frequency of an input signal when a digital signalis input. If the frequency is not known, “unknown” appears onthe front panel display.• Audio Channels:The number of audio channels included in an input signal whena Dolby Digital or DTS signal is input.• Rate (bit rate):The amount of data contained in an input signal per secondwhen a Dolby Digital or DTS signal is input. If the bit rate isnot known, “unknown” appears on the front panel display.• Flg (flag):An identification signal contained in an input signal when aDolby Digital or DTS signal is input. If the flag is not detected,“None” appears on the front panel display. About 96-kHz sampling digitalsignalsThe digital input jacks of this system can handle 96-kHzsampling digital signals. Note the following when 96-kHzsampling digital signal is input to this system:– DSP programs cannot be selected.– Sound will be output as 2-channel stereo from only thefront left and right speakers. (There may be soundoutput from the subwoofer depending on theSPEAKER SET settings on the SET MENU.)Therefore, the level of the effect speakers cannot beadjusted while listening to such a source.Input signalAnalog signalPCM signalDolby Digital signalDTS signalOther digital signalsDisplayAnalogPCMDolby DigitalDTSUnknwn Digital(Unknown Digital)E4-S80-19-26(6.29)b 02.6.29, 4:33 AM25