Yamaha AV-XS80 Owner's Manual

Also see for AVX-S80: Owner's manual

32OPERATING OTHER COMPONENTS USING THE REMOTE CONTROLSetting the manufacturer code (remote control signalassigned to each manufacturer) for your TV, VCR orDVD player on the remote control allows you to operatenot only the AVX-S80 but also your TV, VCR or DVDplayer using the remote control.Note• Depending on the model, certain components from othermanufacturers cannot be controlled, or only limited functionscan be controlled, even though the proper manufacturer codehas been set. If you encounter this problem, please use theremote control supplied with the component.Setting the manufacturer codeManufacturer codes can be set for TV, VCR and DVD/CDbuttons only.Note• TV manufacturer codes can be set for the TV button only.However, any of the manufacturer codes can be set for the VCRand DVD/CD buttons.1 While pressing CODE SET, press the inputselector button (TV, VCR, DVD/CD) for whichthe manufacturer code is to be set.Only one manufacturer code can be set for each inputselector button.Note• Keep pressing CODE SET between step 1 and 2.• Refer to “LIST OF MANUFACTURER’SCODES” at the end of this manual.2 Keeping CODE SET pressed, enter the 1-digit device code and the 2-digitmanufacturer code for the component to becontrolled using the numeric buttons.You can release CODE SET after entering the code.y• The manufacturer code 99 has been set for the remote controlselector buttons (TV, VCR and DVD/CD) at the factory.3 Press POWER (TV or AV) and check that thecomponent to be controlled turns on and off(standby).Precautions when performing the settingYou can operate the component using the TV, VCR orDVD player operation buttons on the remote control oncethe manufacturer code is set properly. If unsuccessful,perform the procedure from step 1 again. Pay attention tothe following points when you perform the procedure.• Check that the correct remote control selector buttonhas been selected when setting the manufacturer code.• If more than one code is given for a manufacturer, tryentering each code in the order given.• Remove and replace the remote control’s batteries(complete this step within 2 minutes) and then performthe procedure. While replacing the batteries, be sure notto press any button on the remote control. Doing somay erase the manufacturer code which has been setfor other remote control selector buttons.To reset the manufacturer code to thefactory-set codeFollow steps 1 to 2 for the procedure “Setting themanufacturer code”, and enter the device code for thecomponent and “99” while pressing CODE SET in step 2.(It is not necessary to follow step 3.)AUDIOPOWERTV MODEPOWERTUNERVCRVIDEO 2VIDEO 1CDENTERTAINMENTROCKJAZZHALL4321MOVIE 2MOVIE 1MONO MOVIESPORTS8765STEREOMATRIX 6.1SELECT/DTSCANCEL1009CODE SETTV AV SLEEPINPUTVOLCHMUTESUBTITLERECTOP MENU MENULEVEL SET MENUTEST B.BOOSTON SCREEN RETURNABCDEMUTEVOLPRESETPRESETENTERCH CHDVDAMPCODE SETTVAVDVD/CDVCRNumeric buttons(U.S.A. model)E7-S80-32-34(5.8)a 02.6.29, 4:34 AM32