SPEC142Route the fuel tank breatherhose along the steering gate.Clamp the compression springsection of the fuel tank breatherhose.Compression springPoint the clip position to theupward.Insert the fuel tank breatherhose until it contacts the projec-tion.To insert the hose, it is allowedto apply oils.To the speed sensor.Clamp the back buzzer lead.Back buzzer(RX10RL, RX10RTRL, RX10GTL,RXW10L)Clamp the radiator fan motorlead and back buzzer lead.To the parking brake.To the brake caliper.Brake hoseClamp the fuel tank breatherhose.Bind the two tube leads on thesteering column side at onepoint by wrapping the tape(black) 3 to 5 turns.The end section of tape shouldnot be peeled.Main switchFlange nutHexagon boltRoute the lead by the inside ofthe wire harness and sub-wirelead (ignition coil lead).Clamp the wire harness, cylin-der identification sensor(together with the connectorcover) and sub-lead wire (igni-tion coil lead).Cylinder identification sensorClamp the wire harness andsub-wire lead (ignition coil lead).CABLE ROUTING
