| Configuring Basic Settings | 1112. Configure and save the following settings:Parameter Description Configuration MethodTime Reminder Enable or disable the systemto display a clock on the hourduring a call.Default: On.Web user interface3. Configure the time and date.Enabling/Disabling the Clock for the VP59After you enable the clock, the time and date are displayed at the center of the Home page. This feature isonly available to VP59.Procedure1. Tap Setting > Basic.2. Enable/Disable Clock.Setting the Ring Tone for the VP59You can set the ring tone for VP59, and the ring tone is available to all accounts registered on VP59.Procedure1. Tap Setting > Basic > RingTone.2. Select the desired ring tone.3. Save the change.Configuring Automatic Sleep TimeStatic images displayed for long periods may lead to monitor burn-in, therefore, you can configure theautomatic sleep time for the device. After the device goes to the sleep mode, “no signal” is displayed onthe monitor.Procedure1. Do one of the following:• On your web user interface, go to Setting > General > General Information > Automatic SleepTime.• For your VC880/VC800/VC500/VC200/PVT980/PVT950, on your remote control, go to More >Setting > Call Feature > Automatic Sleep Time.• On your CTP20, tap Setting > Basic > Automatic Sleep Time.
