| Configuring Content Sharing | 151Configuring Mix-SendingDuring a call, the device of the remote party may not support dual-stream protocol. Therefore, you needenable this feature, so that multiple video streams (the local video + the local content) can be synthesizedto one video stream and sent to the remote.Procedure1. On your web user interface, go to Setting > Video & Audio > Presentation.2. Configure and save the following settings:Parameter Description Configuration MethodMix Enable or disable the mix-sending feature on the system.Note: the default value is On.Web user interfaceNote: If both parties enable the dual-stream protocol, the dual-stream protocol will be used tosend multiple video streams.Configure Content SharingYou can configure whether to enable PC presentation on the system when the content is sharing. You canalso specify the mode, the maximum frame and the resolution for the shared content. Make sure that thedefinition of the presentation is good. You can not configure the content sharing mode for VP59, but youcan configure frame and resolution for VP59.Procedure1. On your web user interface, go to Setting > Video & Audio > Content Sharing.2. Configure and save the following settings:Parameter Description Configuration MethodContent Sharing Mode (it is notapplicable to VP59) Configure the content sharingmode.• Sharing Document- selectthis value to save bandwidthwhen you are sharing adocument. By default, themaximum frame rate is 15fpsand the maximum resolutionis 1080P.• Sharing Video: select thisvalue to play video fluentlywhen you are sharing a video.By default, the maximumframe rate is 30fps and themaximum resolution is 720P.Default: sharing document.Web user interface
