| Configuring Account Settings | 82Setting H. 323 Account/H.323 IP CallThe H.323 protocol is enabled by default. You can place IP calls via the H.323 protocol. If your network usesa gatekeeper, you can register an H.323 account for the system, and specify its H.323 name and extension.This allows others to call you via your H.323 name or the extension instead of the IP address.• Configuring H.323 Accounts• H.323 TunnelingConfiguring H.323 AccountsProcedure1. Do one of the following:• On your web user interface, go to Account > H.323.• On your VCS, go to More > Setting > Advanced > H.323.On your VP59, tap Setting > Advanced > H.323.• On your CTP20, tap Setting > Advanced > H.323.2. Configure and save the following settings:Parameter Description Configuration MethodH.323 Protocol Enable or disable the H.323protocol.Note: the default value is On.Only when it is set to On canthe H.323 account be registered.When it is set to On on bothsites, the devices can call eachother by dialing an IP addressdirectly.Web user interfaceEndpointCTP20H.323 Account Enable or disable the H.323account.Note: the default value is On.If it is set to Off, the devicescannot place or receive calls viathe H.323 protocol.Web user interfaceEndpointCTP20H.323 Name Configure the device namethat can be identified by thegatekeepers and gateways.Note: the default value is blank.If two devices are registered tothe same gatekeeper, they canmake point-to-point calls bydialing their H.323 names.Web user interfaceEndpointCTP20
