| Configuring Network Settings | 61Wireless Access PointFor VC880/VC800/VC500/PVT980/PVT950, you need to connect a WF50 Wi-Fi USB Dongle to the systemfor providing the wireless AP. VC200/VP59 can provide wireless AP directly.• Enabling the Wireless Access Point• Configuring Wireless Access Point• Viewing the Connected Devices• Adding Connected Devices to the Blacklist• Removing Devices from the Blacklist• Disabling the Wireless Access PointEnabling the Wireless Access PointProcedure1. Do one of the following:• On your web user interface, go to Network > Wireless AP.• On your VCS:On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wireless AP.On your VC200, go to More > Network > Wireless AP.On your VP59, tap Setting > Network & Connection > Wireless AP.• If CTP20 is wired to the device, on your CTP20, tap Setting > Advanced > Wired Network >Wireless AP.2. Enable the Wireless AP.3. If you already enabled Wi-Fi, select OK to turn it off.Configuring Wireless Access PointYou can configure the wireless access point for the devices.Before you beginMake sure you enable wireless access point.Procedure1. Do one of the following:• On your web user interface, go to Network > Wireless AP.• On your VCS:On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wireless AP> Configure AP.On your VC200, go to More > Network > Wireless AP > Configure AP.On your VP59, tap Setting > Network & Connection > Wireless AP > Configure AP.• On your CTP20, tap Setting > Advanced > Network > Wireless AP > Configure AP.
