| CEC Monitor Controls | 214Parameter Description Configuration MethodStop Bits Configure the stop bits.• 1• 2Default: 1Note: The stop bits must besame between the controlsystem and Yealink videoconferencing system.Web user interfaceCEC Monitor ControlsConsumer Electronics Control (CEC) is a feature of HDMI designed to allow users to command and controldevices connected through HDMI by using only one remote control. The users can use a remote control tocontrol all the devices connected by HDMI.The CEC feature is enabled by default on VC880/VC800/VC500/PVT980/PVT950 video conferencing system.Ensure that all monitors connected to the system supports and enables the CEC feature. This feature is notapplicable to VC200/VP59.The following CEC features are available:• One Touch Play-Use the system remote control to wake up the monitors. All connected CEC-capablemonitors are powered on, and their displays are switched to VCS input.• System Standby-When the VCS enters sleep mode, all connected CEC-capable monitors are switchedto standby mode for power saving.Note:The VCS does not respond to CEC commands issued by a television remote control.• Configuring CEC Monitor ControlsConfiguring CEC Monitor ControlsProcedure1. On your web user interface, go to Setting > General > General Information.2. Configure and save the following settings:Parameter Description Configuration MethodCEC Enable Enable or disable the CECfeature.Default: On.Web user interface
