START-UPAxioscope 5/7/Vario Mounting standard components ZEISS03/2018 430035-7344-001 473.1.6 Inserting and removing push-and-click (P&C) reflector modules into the reflectorinsertTo install or uninstall the modules, the reflector insert (reflector turret with 4 or 6 coded positions,reflector slider with 2 coded positions) must be removed from the upper part of the stand.Inserting a module:• Remove the reflector insert (315HFig. 3-8/1) from theupper part of the stand (section 3 1 6 H 3.1.7) and putit aside with the top side facing down.• Insert the module (317HFig. 3-8/3) (with the top sidefacing down) with the aid of its mountingelements on its left and right (318HFig. 3-8/4) at aslant from the top into the lower spring clips(319HFig. 3-8/2) on the reflector socket.• Press the module against the upper spring clipsof the reflector turret until it engages firmly.Removing a module:• Disengage the module from the upper spring elements by tilting it forward, then lift it off the lowerspring elements and remove the module.• After installing or uninstalling the reflector module, don’t forget to replace the reflector insert or thecover cap.Fig. 3-8 Changing the reflector module inthe reflector insert
