START-UPZEISS Mounting optional components Axioscope 5/7/Vario76 430035-7344-001 03/2018NOTEThe reflective (coated) side (550HFig. 3-45/3)of the color splitter has a tapered edge(551HFig. 3-45/1) or corner (552HFig. 3-45/2).• Place the excitation part of the module(553HFig. 3-44/1) on the emission part (554HFig. 3-44/4)– holding the fixtures (555HFig. 3-44/5b) and eyelet(556HFig. 3-44/5a) latches together. Hold both partstogether and turn them back into mountingposition.• Replace the slit screws and tighten them.• Finally, attach the label with the name of thefilter combination to the side of the module.3.2.6 Mounting the polarizer D or thefilter holder• For easy assembly, remove the condenser carrier(557HFig. 3-46/3) fully, with the stage carrier.• If necessary, unscrew stop bolt and bracket boltwith low-power system from the condensercarrier.• Hold the polarizer or filter holder (558HFig. 3-46/6)parallel to the bottom of the condenser carrier(559HFig. 3-46/3) and screw the bracket bolt(560HFig. 3-46/4) of the polarizer (561HFig. 3-46/6) withthe angled adjustment lever (562HFig. 3-46/5) intothe front threaded opening at the left belowthe condenser carrier (563HFig. 3-46/3) until it stops.• Screw the stop bolt (564HFig. 3-46/2) with theadjustment lever (565HFig. 3-46/1) to the stop intothe rear threaded opening of the condensercarrier (566HFig. 3-46/3).NOTEProceed similarly when mounting the other components of polarization filter carrier.Fig. 3-45 Labeling the color splitterFig. 3-46 Mounting the polarizer D