50 C HAPTER 4: I NSTALLING THE N ETW ARE C LIENT AND S ERVER D RIVERSIntelligent Auto Install RequirementsTo use the intelligent auto install program: Make sure that your PC has only one EtherLink PCINIC installed. Make sure that you are using NetWare 3.x, 4.x, or 5.x asyour network operating system. Make sure that your PC has at least 1 MB of availablehard drive space.Running the Intelligent Auto Install SoftwareTo run the intelligent auto install software to install theclient software and drivers for a NetWare network:1 Install the NIC and connect it to the network, asdescribed in Chapter 2.2 Reboot to DOS.3 Insert the EtherCD in the CD-ROM drive.4 At the DOS prompt, enter the following command,where d is the drive letter of your CD-ROM drive:d:installThe main menu appears.5 Select Auto Install and Config for NetWare andpress Enter.6 Select DOS, Windows 3.1x, or Windows forWorkgroups 3.11, and follow the instructions.7 When the installation process is finished, remove theEtherCD and reboot the PC.If you are running Windows 3.1x, after you connect tothe NetWare server, run the WSINSTALL program for fullWindows support. Contact your system administrator forthe location of this NetWare utility.
