86 A PPENDIX B: I NSTALLING THE D YNAMICAccess LAN A GENTInstalling the DynamicAccess LAN AgentTo install the DynamicAccess LAN agent:1 Make sure that the NIC and the network driver areinstalled on your PC.See “Verifying Successful Installation” in Chapter 3 toconfirm that the NIC is properly installed in the PC.2 Start Windows.3 Insert the EtherCD in the CD-ROM drive.The EtherCD Welcome screen appears.If the EtherCD Welcome screen does not appear, enterthe following command from Run option of theWindows Start menu:d:\installs\setup.exewhere d:\ represents the letter name of the CD-ROM drive.4 Click NIC Software.5 Click DynamicAccess Technologies.6 Click DynamicAccess LAN Agent.OperatingSystem PC RequirementsRecommendedMicrosoft Service PackWindows 95 486/75 MHz CPU16 MB RAM (32 MB recommended)5 MB available hard drive spaceWindows 95 OSR2 orService Pack 1Windows 98 486/75 MHz CPU16 MB RAM (32 MB recommended)5 MB available hard drive spaceNoneWindows NT 4.0 Pentium/100 MHz CPU32 MB RAM5 MB available hard drive spaceService Pack 3Windows NT 3.51 Pentium/100 MHz CPU32 MB RAM5 MB available hard drive spaceService Pack 5
