122 CHAPTER 12: COMMAND L INE INTERFACEEnabling andDisabling PasswordRecoveryYou can enable or disable password recovery for the Webcache using thepwdRecover command on the Security menu. For more informationabout password recovery, see the “Security”chapter on page 71.CAUTION: 3Com recommends that you leave Password Recoveryenabled. If you disable it and subsequently forget the password for theadmin user name, you will have to return the Webcache to 3Com.To enable or disable password recovery:1 At the Top-level menu, enter:security pwdRecoverThe following example prompt is displayed:The Password Recovery feature is enabled.Enter new value (enable,disable) [enable]:Displaying andChangingWebcacheInformation andFunctionsYou can display and change information about the Webcache using thecommands on the System menu. These commands allow you to: Initialize the Webcache to factory default settings Reboot the Webcache Specify a contact name for the Webcache Specify location details for the Webcache Specify a name for the Webcache Specify a community string for the Webcache Display summary information for the WebcacheInitializing theWebcacheYou can initialize the Webcache using the initialize command on theControl menu.To initialize the Webcache:1 At the Top-level menu, enter:system control initializeThe following prompt is displayed:WARNING: This command initializes the system to factorydefaults (excluding IP details) and causes a reset.Do you wish to continue (yes,no) [no]: