40 CHAPTER 2: INSTALLING THE W EBCACHEFigure 14 User name and password screenIf the user name and password screen is not displayed, see “Solving WebInterface Problems” on page 130.4 Enter your user name and password. For further information, see“Logging in as a Default User” on page 58. Click OK.5 The Getting Started wizard is displayed when the Web interface hasloaded. You must configure the basic settings of the Webcache bycompleting the Getting Started wizard before you introduce theWebcache to your live network. For more information, see “GettingStarted Wizard Settings” on page 43.Setting Up Using theCommand LineInterfaceYou can setup the Webcache for management via the Command LineInterface by running a Telnet session on a management workstation thatis connected to the Webcache over your test network, or locally via aconsole port connection.Setting Up Over the Test NetworkThe Webcache is pre-configured with a default IP address, which is withinthe range of addresses reserved by the IETF for private IP networks. Thisdefault address allows you to run the Command Line Interface withoutany initial configuration of IP addresses. The default IP address of theWebcache is 192.168.1.253.Figure 15 Setting Up Over the Test NetworkClient Machine WebcacheSuperStack 3®3C16116Webcache 3000Power/Self testActivityCache Storage Status green = okyellow = failed green = 100 Mbpsyellow = 10 MbpsLink Status31 2Cache Storage Status32Link StatusActivityLANLANLAN WANSwitch/HubClient Machine
