42 CHAPTER 2: INSTALLING THE W EBCACHEb Tighten the retaining screws on the cable to prevent it from beingloosened.c Connect the other end of the cable to your terminal, terminalemulator, or modem. Make sure that the terminal, terminal emulator,or modem have the same settings as the console port: 8 data bits no parity 1 stop bit2 To configure the settings of the terminal, terminal emulator, or modem,see the documentation that accompanies it. You must configure theterminal and set the line speed (baud) to 9600. You can change the baudrate of the console port via the Web interface.Accessing the Command Line InterfaceTo access the Command Line Interface, take the following steps:1 The login sequence for the Command Line Interface begins as soon asthe Webcache detects a connection to its console port, or as soon as aTelnet session is started.If the login sequence does not begin immediately, press Return a fewtimes until it does begin. If the sequence still does not begin, see “SolvingCommand Line Interface Problems” on page 133.2 At the Login and Password prompts, enter your user name and password.For further information, see “Logging in as a Default User” on page 58.3 If you have logged on correctly, the Top-level menu of the Command LineInterface is displayed as described in “Understanding the Command LineInterface” on page 112. If you have not logged on correctly, the messageIncorrect password. is displayed and the login sequence starts again.4 Access the Getting Started wizard, which allows you to quickly configurethe basic setup information for the Webcache.At the Top-level menu, enter:gettingStarted5 The Getting Started wizard is displayed. You must configure the basicsettings of the Webcache by completing the Getting Started wizardbefore you introduce the Webcache to your live network. For moreinformation, see “Getting Started Wizard Settings” below.
