Section 14 – Programming14-3Programming Point DataEnter the program mode by entering the Service Code at the operating panel.< ? Enter choice:< Lesson Turn on >< See alarms Reset >< Quit More >Action Menu #1 is displayed.Select More three times.< ? Enter choice:< Sys info ID codes >< Name pnt/gps Load >< Previous First >Action Menu #4 is displayed.Select Name pnt/gps to move to the next screen.< ? GROUP #1Group 1< Prev Change >< Quit Next >Group Info Screen is displayed.Enter the point number (e.g., for point 1, enter 1; for point 25, enter25; for point 125, enter 125).< ? POINT 20Pnt 020 Type 1N/Z< Prev Change >< Quit Next >Point Info Screen. is displayed.The first line shows the current name and the second line showsthe point and the type.Note: Type 1N/Z (No Zone) indicates the point is not yet defined.Select Next to display the info for the next point.Select Change to edit the info for this point.< ? POINT 20Pnt 020 Continue >< Back CHR Forward >< Left POS Right >Character Entry Screen is displayed.The cursor is at the first letter of the current name for the point.Use the third key down on each side to move either Back orForward through the alphabet. Use the bottom key on each side tomove the cursor position either Left or Right through the name.Select Continue to save the current name displayed and advanceto the Point Type Screen.Enter the number of the point type.Input Point Types01. BA Fixed (FI) 28. Janitor Keyswitch (PID only) (JAN)02. BA Movable Instant (MI) 29. BA Keyswitch (PID only) (KEY)03. BA Movable Delayed (MD) 30. Remote Power Supply (RPS)04. BA Fixed Local (FL) 31. BA End Delay (PID only) (END)05. BA Movable Instant DaytimeAnnunciation (MID)32. BA Blocklock (PID only) (BLK)06. BA VVS (VVS) 35. Ambush Start (ABS)07. BA Movable Instant Chime (MIC) 36. Ambush End (ABE)08. BA Movable Delayed Chime (MDC) 60. Manual Access Pushbutton (MAP)09. Fire (FA) 64. Exit Pushbutton (EXP)10. Holdup Special (HUS) 65. RF Arm (ARM)11. Holdup (HU) 66. RF Disarm (DAR)13. Supervisory (SPV) 67. RF No Alarm Response (NAR)Output Point Types14. Central Station AC (CSC) 24. Holdup Suspicion (HSC)15. Service Mode (SMC) 25. BA Remote Sonalert (RSC)16. Telco Fault TFC) 26. BA Bell/Vault Sensor Test (TSC)17. BA Schedule (SCC) 27. Remote Bell (PID only) (RBL)18. BA Lights (LTC) 33. System Trouble (STC)19. BA Fixed (FXC) 34. Point Link (PLC)20. BA Off (OFC) 37. BA Access (ACC)21. Fire (FAC) 38. Horn/Strobe (SIM Only) (HST)22. Supervisory (SPC) 59. Access Denied (ACD)23. Holdup (HUC)< ? FRONT DOOR 20Type N / Z Continue >Type – 0 0< Quit Delete >Select Delete to erase all the info for this point.
