Section 14 – Programming14-7< ? Grp0 Ut0 Keypad< BA-y y y y y y y y< Previous Change >< Quit Next >This screen shows which BA Groups will be automatically opened(turned off) when a valid ID Code is entered at the operating panelindicated.Select Change to edit the selections. Enter the number of each BAGroup that will turn off. Entering the number again will erase theselection.Select Next to move to the operating panel at the next address onthe RS-485 bus.Continue until all operating panels have been programmed.< ? Grp4 Ut0 Cardrdr< BA-y y y y y y y y Lg (N) >< Previous Change >< Quit Next >Selecting Next at the last operating panel will bring you to thisscreen.This screen is same as the one for the operating panels, except thisis for BA Groups linked to card/key readers.Select Change to edit the selections.Select Next to move to the card/key reader at the next address onthe RS-485 bus.Selecting Lg will toggle between Yes (Y) and No (N) to logsuccessful attempts, unsuccessful attempts, openings, and closingsat this card/key reader in the history log.Selecting Next at the screen showing the last card/key reader willbring you to the Point Data Info Screen.Select Quit to return to Action Menu #4.Programming the System Communication OptionsEnter the program mode by entering the Service Code at the operating panel.< ? Enter choice:< Lesson Turn on >< See alarms Reset >< Quit More >Action Menu #1 is displayed.Select More three times.< ? Enter choice:< Sys info ID codes >< Name pnt/gps Load >< Previous First >Action Menu #4 is displayed.Select Load to continue.< ? SS-GG-IIII >< ST P# Remote DLL >< DTM/Lst Local DLL >< Quit More >The Communication Screen is displayed.Select More to program the CCC phone number.< ? Pri Num/Hex Edi< Pri Phone Num< Pls/Lst CID >< Quit Hex Data >The CCC Options Screen is displayed.Select the Pls/Lst key to scroll through the dialing methods. Thechoices are:Pls/Lst = Pulse dialing and loop startDtm/Lst = TouchTone dialing and loop startPls/Gndst = Pulse and ground startDtm/Gndst = TouchTone and ground startSelect the CID key to toggle between Contact ID (CID) andSecurity Industry Association (SIA) formats.Select Pri Phone Num to program the primary CCC phonenumber.Select Hex Data to program the hex data information.
