FOCUS 200 PLUS Installation and Setup Guide5-18Step Action5 Snap the Trunk Junction box SCN 148320 around the connections to enhanceappearance.6 Connect the branch cable to the SIM or SIM Sensor. SIM sensors that have screwterminals include the smoke detector, the FA Pullbox, motion sensors, and thehorn/strobe. Connect these directly to the branch cable.7 Splice the SIM module to the branch cable. Use SCN 810953 connectors to splice to thebranch cable.8 Collect the point description, gateway number, and Hard ID's of all installed SIMs sothey can be programmed into the control unit. Use the Gateway Trunk Log Form torecord the Gateway, Hard ID, BA Group, and point description. Once the data has beencollected, it must be entered into the control unit via the operating panel. See theProgramming section for the procedure. Once the data has been programmed, any walk-tests LEDs will function.The Hard ID label: The top line is the barcode. The second line is in readable text. Thefirst eight digits are the Hard ID. The next six digits are the Stock Code Number (SCN#). The next four digits are the manufacturing date codes ("year week"). The last twodigits are for the vendor codes like "P" for Pine Brook.9 Mark the SIM Sensor point number stick-on labels SCN 146844. Peel off the numberthat represents the point number and stick it on the outside of the sensor so it is clearlyvisible and can be referred to later.Sensors cannot be walk-tested unless the sensor's point type, group, gateway, and Hard ID are in thecontrol unit's database.IN 0IN 2C52.3 uf25VOUT 0YELCOM ( )BLUCOM ( )+BLKGNDRED+12VGATEWAYTRUNKCONNECTIONSTRANSISTORSWITCHRED-WHTBLK-WHTORGAL-TBLBLU-WHTTMPRWHT+12V472366 SIM+12VGND+12VGNDOUTPUT POWER(FOR INPUT POINT, TRANSISTOR SWITCH ISCONTINUOUSLY CLOSED TO SUPPLY SENSOR POWER.FOR OUTPUT POINT, TRANSISTOR SWITCH CLOSES ONLYWHEN COMMANDED FROM CONTROL UNIT.)SYSTEM-POWEREDSENSORW/ TRANSFER CONTACTSAND TAMPERNON-POWEREDSENSORW/ BREAK-ONLY CONTACT(NO TAMPER)IN 0IN 2MICROPROCESSORINPUTOUT 0 MICROPROCESSOROUTPUTCONDITION IN 0 IN 2NORMAL 6V GNDALARM GND GNDTAMPER 6V 12VOPEN LOOP 12V 12VCONDITION IN 0 IN 2NORMAL 6V GNDALARM 12V GNDTAMPER 6V 12VOPEN LOOP 12V 12VTFigure 5-7: SIM Wiring to System-Powered and Nonpowered Sensors
