FOCUS 200 PLUS Installation and Setup Guide7-4Description of ADEMCO Contact ID FormatWhen using ADEMCO Contact ID, the FOCUS 200 PLUS system transmits the data in DTMF (DualTone Multi-Frequency). This format requires the 1400hz/2300hz dual tone handshake and the 1400hzkissoff tone. The signal is comprised of a 4-digit subscriber number, 1-digit event qualifier ("new" or"restore"), 3-digit event code, 2-digit BA group number, and 3-digit zone number, user number, orsystem status number.ADEMCO Contact ID Reporting takes the following format:CCCC QEEE GG ZZZwhere: CCCC = Customer (subscriber) IDQ = Event qualifier, where:E = new event, and R = restoreEEE = Event code (3 hexadecimal digits)GG = BA Group number (system messages show “00”)ZZZ = Point number reporting the alarm, or user number for Open/Close reports.System status messages (AC Loss, Walk-Test, etc.) contain zeroes.Contact ID Event Codes and ADT SIA Report CodesDescription Printable-OnlyEventADEMCOCIDADTSIASystem EventSystem Reset XReset Memory XAC Fail 301 AAAC Restore 301 AHAC Fail 4-Hour 926 ATAC Fail 4-Hour Restore 926 AJTelco Line Trouble (Line 1 or Line 2) 350 LTTelco Line Trouble Restore (Line 1 or Line 2) 350 LRLow Battery System 302 YTLow Battery System Restore 302 YRChange Date XExpansion ModuleInteractive Keypad Tamper 143 IAInteractive Keypad Trouble − supervision 333 ITInteractive Keypad Trouble Restore 143 IRCardreader Alarm 143 DACardreader Trouble 333 DTCardreader Trouble Restore 143 DRPoint Gateway Tamper Alarm 143 EAPoint Gateway Trouble − supervision 333 ETPoint Gateway Trouble Restore 143 ERPrinter Tamper Alarm 336 PAPrinter Trouble − supervision 333 PTPrinter Trouble Restore 336 PRRF Low Battery 384 WLRF Low Battery Restore 384 WRAC Module Communication Failure YCAC Module Communication Failure Restore YO
