FOCUS 200 PLUS Installation and Setup Guide18-4< ? PERSON #1Access irr & open< ** BA Group 1< Change Continue >This brings you to the first in a series of nine Person AccessScreens.Select Change to scroll through the following four choices ofaccess:1. Can access & open2. Can not access3. Can access4. Access irr (irregular) & openSelect Continue to save the displayed access capability, andadvance to the first access screen for BA groups 2-8.** Pressing the BA Group button at any of the Person AccessScreens brings you to the previous screen.< ? PERSON #1Can not open irregular< BA Group 8< Change Continue >Selecting Continue at BA Group 8 brings you to the next in theseries of access screens. The series of access screens progress asfollows:Can (not) open irregularCan (not) bypass BACan (not) change temp schedCan (not) change perm schedCan (not) change namesCan (not) bypass FA/HU/SPVCan (not) enter service modeCan (not) be changedNote: The Janitor privileges may be set up only via downlineloading.Select Change to toggle a privilege between Can and Can not.If the last access screen displays “Can not be changed,” selectingContinue advances you to the Enrolling Key or Card Screen. Seethe Access Control section for the procedure for enrolling cardsand/or keys.If you are adding a new ID Code or changing an existing ID code,make sure the last access screen displays “Can be changed.” SelectContinue at this access screen for BA group 8 to advance to theType New User Screen.< Type New UserID code:01 _ _ _ _< Quit Enter >Type New User Screen is displayed.Enter the last 4 digits of the ID code for the user number displayed.The first 2 digits of the ID code are the user number. The screen atthe right shows user # 01.Select Enter to save the ID code displayed.Select Quit to go back to Action Menu #4.Summary of ID Code Capabilities and PrivilegesThe following operations can be performed by a user, provided:1. The Operating Panel has been activated by a valid code.2. The user has the appropriate privilege level.Protection On/Off• Turn the protection On for one or any combination of BA groups.• Turn the protection Off for one or any combination of BA groups (turnoff is automatic upon entry ofa valid code if the BA group is in entry delay or alarm).• Establish automatic On and/or automatic Off schedule (if system option has been enabled).
