FOCUS 200 PLUS Installation and Setup Guide14-6< ? FRONT DOOR 20Gate? Continue >POINT GATEWAY< Previous Delete >This is the Gateway Screen.Enter the Gateway unit number (0-7) that this point is associatedwith.Select Continue to save the info and move to the next screen.< ? FRONT DOOR 20Gate 1 Continue >POINT GATEWAY< Previous Enter >Select Enter and then Continue to save this info and move to thenext screen.< ? FRONT DOOR 20< Replace (N) Done >Hard ID: _ _ _ _ _ _ _ _< Previous Enter >This is the Hard ID Screen.Enter the Hard ID number of the device for the point.If this is an RF point, enter the serial number located on the barcode label on the transmitter.Select Enter and then Done to save this info and move back to thePoint Info Screen.Note: The Replace (Y/N) has no function at this time.< ? FRONT DOOR 20Pnt 20 Type 3MD< Prev Change >< Quit Next >This is the Point Info Screen.This screen now displays the summary information for the point.The first line shows the current name and the second line showsthe point and the type.Select Next to display the info for the next point.Select Previous to move back to the previous screen.Select Change to edit the info for this point.Select Quit and move to Action Menu #4 when all points have beenprogrammed.Programming the BA Groups' Turn-Off DataEnter the program mode by entering the Service Code at the operating panel.< ? Enter choice:< Lesson Turn on >< See alarms Reset >< Quit More >Action Menu #1 is displayed.Select More three times.< ? Enter choice:< Sys info ID codes >< Name pnt/gps Load >< Previous First >Action Menu #4 is displayed.Select Name pnt/gps.< ? BA GROUP #1Group 1< Previous Change >< Quit Next >Group Info Screen. The system defaults to display the info forGroup #1. The top line shows the current name. The second lineshows the group to which this info pertains.Select Next repeatedly until the info screen for Group #8 is shown.Select Next once more to advance to the next screen.
