FOCUS 200 PLUS Installation and Setup Guide15-2User Access LimitationsUsers are assigned privilege levels, which either allow or deny access to a BA group when it is normallyclosed. The privilege of entering a BA group outside of the schedule can be assigned to any ID code.Anyone who does not have this privilege and uses their ID code to access a BA group prior to thescheduled open time will cause an Irregular Opening. The signal will be received at the CCC and theowner or manager will be notified.Close Time TimerThe Close Time Timer counts down from the opening of a BA group until closing. The system transmitsto the CCC a No-Close signal if the group is not closed when the countdown is completed.Permanent SchedulesThe permanent schedule has two open and close times that can be programmed for each day in theweek. The times can be changed only by someone who has an ID code with the privilege to change apermanent schedule. This privilege also permits a person to make changes in real time.Permanent Schedule Programming OptionsPermanent schedule programming options are for establishing the daily opening and closing schedulesand for determining if changes will be permitted.The permanent schedule programming options are as follows:Schedule Option DescriptionPermanentOpen Time00:00 to 23:59 The time range for selecting a permanent opening time inhours and minutes.UUUU There will not be a permanent opening schedule for the BAgroup, although a temporary opening schedule can be used.NNNN No permanent open time is assigned, nor can a temporaryschedule be entered via keypad.PermanentClose Time00:01 to 23:44 The time range for selecting the scheduled closing time inhours and minutes. A closing time between 11:45 PM and11:59 PM is not permitted.UUUU No permanent closing schedule is assigned, but a temporaryclosing schedule can be used when necessary.NNNN No permanent close time has been assigned, nor can one beentered via the keypad.Example of a Permanent ScheduleA facility is closed on Sunday, and is scheduled to open at 9:00 PM on Monday and close at 1 AM onTuesday. The table below shows the programming to establish this schedule for an entire week:Day of Schedule ProgrammingEntry ResultMonday FirstOpening Time21:00 PM This starts the open period time window (9:00 PM) forMonday.Monday FirstClosing TimeUUUU This inhibits "close reminder/warning" and "no close" fromoccurring because the premises will not close on Monday.Tuesday FirstOpening Time12:00 AM This entry is needed because the open time period wasstarted on Monday and allows any closing time to be enteredfor Tuesday.Tuesday FirstClosing Time01:00 AM This completes the time window that started at 9:00 PM onMonday.Tuesday SecondOpening Time21:00 PM This starts the open period time window (9:00 PM) forTuesday.
