FOCUS 200 PLUS Installation and Setup Guide19-2Activating the Operating PanelIf the system is in a normal, non-alarm state, pressing any digit key activates the operating panel todisplay the off/on status of the burglar alarm protective group(s).Entering a valid 6-digit ID code causes the operating panel to activate, bringing up the Action Menus.Then selections and entries can be made as required.Screen Duration of the Operating PanelIf, while you are in the process of performing an operation, a predetermined period elapses withoutmaking a selection, the display will revert to the screen showing the status of the system, provided thatall parts of the system are normal.The various screen durations are as follows:Screen DurationNormal no-alarm 7 secondsAction Menu #1 screen Approximately 10 secondsAfter a selection at Action Menu #1 60 secondsAfter an ADT Service Code is entered 4 minutesTest In Progress Continuously until resetOperating Panel SounderThe operating panel sounder will annunciate to signal specific conditions as follows:Condition Sounder PatternEach depression of a selector button or digit key A short beepAcceptance of a valid code or a function A longer beepFire Alarm Pulsating 1-second-on, 1-second-off with a 5-second pause every 10 secondsBA Alarm Steady toneTrouble or Supervisory Intermittent pulsating (2 beeps, 1 second off)Entry Delay−reminder to turn off Steady toneExit Delay−reminder to exit 1-second beep every minuteEnd of Exit Delay 4-second beepAuto On Reminder−reminder to close (beeps start15 or 30 minutes before closing, as programmed)1-second beep every minuteAuto On Warning−warning to either exit or extendclosing time (beeps start either 5 or 15 minutesafter closing, as programmed)Steady toneAudible-on-Schedule Enable (if optioned) 1-second beep every minuteTest Mode in Progress 1-second beep every minuteDuring Audible Walk Test Pulsating 1-second-on, 1-second-offWhen a sensor is activated during the walk test Steady toneAction MenusOperation of the system is based on selecting a course of action from menu items that appear on aseries of screens known as Action Menus. Provided the associated BA protection is off, entering a validID code causes the first of four Action Menus to be displayed.The Action Menus are the starting point for performing all operations other than turning the systemoff. Selection of a menu item results in the display of another screen. Continue making selections untilthe appropriate screen is displayed and the desired course of action has been completed.The four Action Menus and the explanation for each of the keys at each menu follows.
