Section 18 – ID Codes18-3For example, if the ID code is 2-2-4-5-6-7, enter 2-2-4-5-6-9 to activate a duress signal. If the last digitof the PIN is 8, enter 0; if the last digit is 9, enter 1; if the last digit is 0, enter 2. The duress signalworks with any valid ID code regardless of the privilege level.Programming ID CodesThe deletion, addition, or alteration of the PIN (last four digits) of an ID code and associated user namecan be performed at any operating panel by a user with an ID code having this privilege, or the changecan be downline loaded from the central station. Where PCS (Passcode Schedule Supervision) service isinvolved (see the System Communication section), instruct the customer that ID code changes must becontrolled from the CCC because the CCC monitors those who perform BA group openings. With thistype of service, the CCC can prevent the customer from changing an ID code.ID Code Programming OptionsProgramming options associated with each ID code are as follows:Option FunctionCode These are the last four digits of the ID code. They are entered alongside the twodigits that serve as the user number in order to make up the 6-digit ID code.Group The choice of BA groups that the ID code will have access to. The selection caninclude any combination of groups, including all groups.Cancellation Date A cancellation date can be assigned to any ID code up to 365 days in advance.Note: The privilege "Can enter service mode" is reserved for ADT personnel and must not beassigned to any ID code being used by the customer.If an RF button is linked to a user code, when the user code cancel date expires the link issevered. Entering a new cancel date does not re-establish the link to the RF button.Adding or Changing an ID CodeTo add or change an ID code, enter a user ID code with the privilege to change ID codes or enter theService code at an operating panel and perform the following:< ? Enter choice:< Lesson Turn on >< See alarms Reset >< Quit More >Action Menu #1 is displayed.Select More three times.< ? Enter choice:< Sys info ID codes >< Name pnt/gps Load >< Previous First >Action Menu #4 is displayed.Select ID codes.< PERSON #1USER 001 Delete >< Previous Change >< Quit Next >Person Data Entry Screen is displayed.The system defaults to user #001. If this is not the user you desireto change the data for, enter the correct user number.Select Next to advance to the next user number.Select Previous to back up to the previous user number.Select Delete to erase the data for the user displayed.Select Quit to go back to Action Menu #4.Select Change to edit the data for the user displayed.< PERSON #1< Back CHR Forward >< Left POS Right >< Quit Continue >If you selected Change, the Person’s Name Screen is displayed.The cursor is at the first letter of the current name for the user.Use the second key down on each side to move either Back orForward through the alphabet. Use the third key down on eachside to move the cursor position either Left or Right through thename or to insert a space.Select Continue to save the current name displayed and move tothe next screen.
