FOCUS 200 PLUS Installation and Setup Guide20-2To test the LCD display:Step Action1 Enter the operating panel test mode by pressing the [1] and [8] keys simultaneously. Thesystem displays the operating panel and system information.2 Once "WAIT" is displayed, enter the operating panel code (1, 2, 3).3 Press the Test LCD selector button. All the pixels on the display screen light up.4 Press any key. The screen goes blank.5 Press any key. All alphabetic characters and numbers are displayed.6 Press any key. The keypad test screen is displayed.7 Press Quit to return to the operating panel and system information screen.8 Press Quit again to return the normal operation screen.Local TestsThe local tests are typical of a local-only system because they do not involve the CCC. Perform a systemtest by activating each sensor, in turn, and verifying that the alarm condition is properly displayed onthe operating panel(s), and that the panel sounder functions properly. Indicate the results on theappropriate ADT form. Inspect the system performing the various tests and battery check. If problemsare encountered, troubleshoot and repair as needed.Before performing the Burg pts audibly test (described in Additional Test Options), all points to betested in this mode must be bypassed.Enter the Service Code and then proceed as follows:< ? Enter choice:< Lesson Turn on >< See alarms Reset >< Quit More >Action Menu #1 is displayed.Select More.< ? Enter choice:< See points Test >< Change close time >< Previous More >Action Menu #2 is displayed.Select Test.< ? Test:Burglary groups >Sensor points >< Quit More >The Test Screen is displayed.Select Burglary groups to test a particular BA Group.Select Sensor points to test particular types of points within a BAGroup.Select More to display additional test options (Bell & Display andBurg points audibly).Select Quit to return to Action Menu #2.When any of the Local Tests are selected, the sensitivity of the RF receiver is reduced by approximately50%, if RF points are programmed in the system.
