5-3WindowsConfiguring Ports1 From the Driver Configuration dialog box, select theappropriate connection type for your network. AutodetectDefault Connection is the recommended choice. For anexplanation of possible options see Connection Types onpage A-2.Click OK.2 The Driver Configuration dialog box will display again foreach NIC installed. Repeat Step 1 for each of these NICs.Note: For multiport NICs, the Driver Configurationdialog box will display again for each port.Each NIC can be identified by its unique PCI Bus/PCI Slotnumber.3 If SNMP has not been set up on this computer you will receivethe following Setup message:Install the NT SNMP service and use configure option toconfigure Server related MIBs.Click OK.Configuring Protocols1 In the Network Setup dialog box click the Bindings tab.2 In the show bindings drop-down box, highlight all protocols.3 Highlight the protocols you wish to bind and click Enable.Disable all other protocols.4 Click OK.5 Click Finish in the Network Settings dialog box and rebootyour system for the settings to take effect.
