9-3Installing Duralink Drivers for Windows NT2 To remove any currently installed Adaptec NICs highlight thename, click Remove, then click OK. Repeat until all AdaptecNIC drivers are removed.3 Click Close to close the Network dialog box.4 Click Yes to restart your computer.Note: When you restart Windows NT, a message mayindicate that at least one service failed to start. Thismessage will not appear after you add the newDuralink drivers in the following steps. Click OK.Adding NIC Drivers1 Double-click the My Computer icon.2 Double-click the Control Panel icon.3 Double-click the Network icon.4 Click the Adapters tab in the Network dialog box.Note: Do not allow Network Setup to autodetect theinstalled NICs.5 Click Add.6 Click Have Disk.7 At the prompt Insert disk with software provided by thesoftware or hardware manufacturer, insert the DuralinkFailover diskette in your floppy drive. Enter the path to thedirectory where the driver andoemsetup file are located(a:\winnt\i386 or b:\winnt\i386). Click OK.
