10-110t t t tInstalling Duralink Driversfor NetWareThis chapter describes how to install the Duralink Failover utility ona server running NetWare 4.1x/3.1x. Instructions in this sectioncover both initial installation from thefosetup.nlm file contained onthe Duralink Installation Diskette, as well as instructions onchanging the configuration using thefoconfig.nlm utility (residingon the server after installation). Use foconfig or fosetup to install orconfigure Duralink Failover. Otherwise, fostatus may not show theproper configuration.Installation OverviewThe following procedures are covered in this chaptern Removing Previously Configured Drivers on page 10-2n Initial Installation and Configuration of Duralink Failover onpage 10-3n Viewing System Status Using fostatus.nlm on page 10-10n Network Client Setup on page 10-12n Reconfiguring Using foconfig.nlm on page 10-12Installation, configuration, and optional parameters for the DuralinkFailover utility are updated regularly. Thereadme subdirectorycontains supplemental installation instructions, as well asinformation about optional keywords.
