10-3Installing Duralink Drivers for NetWareInitial Installation and Configuration of DuralinkFailoverConfiguration for Duralink Failover is done through a Setupprogram that is contained on the NetWare Duralink InstallationDiskette. This program will install the necessary files required forrunning the program through NetWare onto your hard drive. TheSetup program allows you ton Configure portsn Configure Failover Pairs—assigning names, deleting andadding ports to groups for load balancingn Configure protocols for stand-alone ports or groupsn Update filesInstalling the Failover Software using fosetupAt the prompt, type load a:\nwserver\fosetup.A message indicating the number of ports is displayed. Press Esc toenter the setup module.F KeysF1— provides on-line help for each screen.F10— allows you to abort any changes you have made fromwithin the program and exit the utility.Duralink Failover Setup V2.1< F1> Help©Netware Loadable ModuleMain MenuConfigure PortsSet Failover PairsConfigure ProtocolsView ConfigurationInstall SoftwareUninstall SoftwareUse arrow keys to move, to Select, to Exit.Copyright 1998, Adaptec Inc. < F10> Abort Setup
