10-2Fast Ethernet Network Interface CardsRemoving Previously Configured DriversIf you have installed Duralink or Adaptec Ethernet drivers prior tothis installation, complete this section. This is to ensure that noconflicts exist between previously installed drivers and DuralinkFailover. Do not install Duralink Failover 3.0 over 2.0.1 Remove all load and bind commands related to EMPCI,failover.ncf,fover.ncf orloadbal.ncf from theautoexec.ncf.Caution: Be sure to remove only these commands.Errors may result in problems with other programs orsystem components!2 At the server prompt, type load inetcfg and press Enter.3 Select Boards and press Enter.4 Delete all existing EMPCI boards by selecting each andpressing DEL.5 Press ESC to exitinetcfg.Fresh NetWare InstallationIf you are loading NetWare on a new server, do not add aLAN/Ethernet adapter when prompted in the NetWare setupprocedures. When prompted to add a LAN adapter, select No andcontinue with the NetWare installation. Then proceed to thefollowing section.!
