6-3UNIXSCO UnixWareThis section describes how to install LAN drivers for UnixWare. Thedriver for this operating system is located on Diskette 1 in the/UNIXWARE directory.The SCO UnixWare driver supports up to four ports for the sametype of NIC. It does not support a mixture of NICs at the same time.Note: All commands in Unix are case sensitive. Be sure totype all commands exactly as shown.Removing Previously Configured DriversBefore adding the Adaptec NIC you must first remove any previousdriver package, then reinstall it for the new NIC.1 As the root user, remove the package by typing pkgrm EMPCI.Follow the online prompts to remove the package.2 Shut down the system, replace the NIC and reboot.Adding NIC Drivers1 After booting up with UnixWare, press contrl/alt/sys rq andthen P to go to the system command line prompt.2 Login as the root user.3 Insert Diskette 1 in drive A. To copy the compressed driver filefrom the floppy drive to the local hard disk, typedoscp a:/unixware/EMPCI.Z /tmp/EMPCI.Z4 To uncompress the file typeuncompress /tmp/EMPCI
