10-5Installing Duralink Drivers for NetWare3 Select the appropriate connection type for your network.Autodetect (default) is the recommended choice. For anexplanation of possible options see Connection Types onpage A-2.Note: The Thin (BNC) connector is not supported forDuralink Failover.You can set configuration parameters but leave the settingsDisabled for use at a later time by pressing Tab while the portis selected.4 Press Esc when you have completed port configuration.Setting Failover Pairs1 Select Set Failover Pairs from the Main Menu and press Enter.Autodetect (default)Autodetect (default)Duralink Failover Setup V2.1< F1> Help©Netware Loadable ModuleAutodetect (default)10 Mbps UTP/Half Duplex10 Mbps UTP/Full Duplex100 Mbps UTP/Half Duplex100 Mbps UTP/Full DuplexThinType of ConnectionUse arrow keys to move, to Select, to go back to the previous menu.Copyright 1998, Adaptec Inc. < F10> Abort Setup1 Empci12 Empci2No. Port Name Connection TypeMain MenuConfigure PortsSet Failover PairsConfigure ProtocolsView ConfigurationInstall SoftwareUninstall Software
