Chapter 5: Local Management5-582E43-51/2E43-51R User’s Guide5.16.2 Changing Source and Destination PortsAdd or delete source port and destination port entries as follows:1. Use the arrow keys to highlight the Source Port field.2. Press the SPACE bar or BACKSPACE one or more times to incrementor decrement the port number displayed in the brackets [n] until theappropriate port number displays.3. Use the arrow keys to highlight the Destination Port field.4. Use the SPACE bar or BACKSPACE to step to the appropriate portnumber for the destination port.5. Use the arrow keys to highlight the Status field.6. Use the SPACE bar to select either the ADD or DEL (delete) option.Press ENTER. This adds or deletes the port selections made in steps 2and 4 and also updates the screen Source Port and Destination Port list.7. Use the arrow keys to highlight SAVE at the bottom of the screen.Press ENTER. The message “SAVED OK” displays. This saves thenew settings and updates the Source Port and Destination Portread-only fields.5.17 BROADCAST SUPPRESSION SCREENThe Broadcast Suppression screen, Figure 5-24, allows the user to set adesired limit of receive broadcast frames that are switched out to the otherports.NOTETo redirect more than one port, repeat steps 1 through 6 foreach additional setting, then go to step 7 to save all the newsettings at once.NOTEThe Broadcast Suppression screen is not available if theoperational mode of the device is set to SECURE FAST VLAN.This screen may only be used when the device is configured tooperate as an 802.1D or 802.1Q switch.Broadcast frames received above the threshold setting aredropped.
