Chapter 5: Local Management5-622E43-51/2E43-51R User’s GuidePORT LEVEL SECURITY CONFIGURATIONUsed to set the security for each port of a connector, individually. Fordetails, refer to Section 5.20.5.19 REPEATER LEVEL SECURITY CONFIGURATIONThe Repeater Level Security Configuration screen, Figure 5-26, is used toset the state of security for all ports on a connector. A connector can be setto receive all frames (NonSecure state), lock on the source address of thenext frame received (LockOnNext), or lock on the source address of thelast frame received (LockedOnAddr). When either of the last two optionsare set, the switch can be set to receive or not receive frames and to sendor not send traps when an intruder is detected.To access the Repeater Level Security Configuration screen, use the arrowkeys to highlight the REPEATER LEVEL SECURITYCONFIGURATION menu item on the Repeater Configuration Menuscreen and press ENTER. The Repeater Level Security Configurationscreen displays.Figure 5-26 Repeater Level Security Configuration Screen2E43-51 LOCAL MANAGEMENTRepeater Level Security ConfigurationModule Type: 2E43-51 Firmware Revision: XX.XX.XXBOOTPROM Revision: XX.XX.XXInterface State Lock/Learn Action On Intruder1 [Secure] [LockOnNext] [DisablePort] [SendTrap]2 [Secure] [LockOnNext] [DisablePort] [SendTrap]3 [Secure] [LockedOnAddr] [DisablePort] [SendTrap]4 [NonSecure]SAVE EXIT RETURN2251_112
