Chapter 5: Local Management5-502E43-51/2E43-51R User’s Guide3. Use the arrow keys to highlight the SAVE command. Press ENTER.The message “SAVED OK” displays and Local Management savesthe changes to memory. The selected mode is displayed in both theDesired Operational Mode field and the Current Operational Modefield.5.14.2.2 Setting the FE-100TX Advertised AbilityIn normal operation, a port (5 or 6) with an FE-100TX auto-negotiates tothe highest speed possible. Under some circumstances, the NetworkAdministrator may want the port to advertise only some of the availablemodes. The Advertised Ability field provides the capability to set thosemodes. This field steps to 10Base-T, 10Base-TFD (full duplex),100Base-TX, and 100Base-TXFD (full duplex). To set the advertisedability, proceed as follows:1. Use the arrow keys to highlight the Advertised Ability field.2. Use the SPACE bar to select the desired mode.3. Use the arrow keys to move to the Enable/Disable field at the right ofthe desired mode and use the SPACE bar to select Enabled orDisabled. Press ENTER.4. Continue this process until you have completed enabling or disablingthe advertised modes.5. Use the arrow keys to highlight the SAVE command. Press ENTER.The message “SAVED OK” displays and Local Management savesthe changes to memory.5.15 FLASH DOWNLOAD SCREENThe Flash Download screen, shown in Figure 5-22, allows the user toupgrade the device with a different operating image.NOTEThe user may also force the download of an image by changingthe position of Switch 6 located inside the device. For detailsabout setting the switch, refer to Section C.2.1.
