4-12 Instruments and ControlsTo calibrate the compass, use thefollowing procedure:Compass Calibration Procedure1. Before calibrating the compass,check that the compass is set tothe correct variance zone. See“Compass Variance (Zone)Procedure” earlier in thissection.Do not operate any switchessuch as window, sunroof,climate controls, seats, etc.during the calibration procedure.2. Press the vehicle informationbutton until Press To CalibrateCompass displays.3. Press the set/reset button tostart the compass calibration.4. The DIC will display CalibratingDrive In Circles. Drive thevehicle in tight circles at lessthan 8 km/h (5 mph) to completethe calibration. The DIC willdisplay Calibration Complete fora few seconds when thecalibration is complete. The DICdisplay will then return to PressTo Calibrate Compass.ClockThe analog clock is located on theinstrument panel above the radio.The clock is not connected with anyother vehicle system and runs byitself. To adjust the clock:1. Locate the adjustment buttonsdirectly below the clock face.2. Push and hold the rightadjustment button to move theclock hands forward or the leftadjustment button to make theclock hands go backward.Holding either button down willcause the clock to advancefaster. Release the button beforethe desired time is reached.3. Push and release either buttonto adjust the time by one minuteincrements until the desired timeis reached.Power OutletsAccessory power outlets can beused to connect auxiliary electricalequipment, such as a cellulartelephone.There are three accessory poweroutlets. There is an outlet located inthe front storage area below theclimate control system, one insidethe center console storage bin, andone on the rear of the centerconsole.For CTS Wagon model only, there isan additional accessory poweroutlet located near the rearcargo net.Ofrecido por www.electromanuales.com
