Handling rollsLoading Rolls on the Roll HolderWhen printing on rolls, attach the Roll Holder to the roll.Attach the 2-inch or 3-inch paper core attachment to the roll holder, depending on the size of the paper core of theroll you will use. The printer is delivered with the 2-inch paper core attachment installed. (→P.131)Important• Cut the edge of the roll paper if it is uneven, dirty, or has tape residue. Otherwise, it may cause feedingproblems and affect the printing quality. Be careful not to cut through any barcodes printed on the roll.• Wind up the roll so that the edge is even across the roll. This may cause feeding problems.Caution• Set the roll on a table or other at surface so that it does not roll or fall. Rolls are heavy, and dropping aroll may cause injury.Note• For details on supported sizes and types of rolls, see “Paper Sizes” or the Paper Reference Guide.(→P.101) (→P.95)• After pressing the Load/Eject button, you can refer to instructions on the Display Screen as you loadthe paper.1. Lift the Holder Stopper lever (a) from the shaft side to unlock it. Holding the Holder Stopper atthe position indicated (b), remove it from the Roll Holder.Handling Paper 107
