Handling sheetsManually Loading Paper to the Position for PrintingYou will need to advance the paper manually to the starting position for printing after selecting the type ofpaper in the Control Panel menu when rolls or sheets are loaded in the following cases, which require adifferent paper feeding method than usual.• RollsIf you select a type of paper for which Width Detection is Off when Chk Remain.Roll is also Off• SheetsIf you select a type of paper for which Width Detection is OffIn these cases, printing starts from the position at which the paper has been loaded, so you must load thepaper as far into the Paper Feed Slot as possible.Manually advance paper as follows.1. When Width Detection OFF. OK to continue? is shown on the Display Screen, press ▲ or ▼to select Leave OFF and then press the OK button.If you select Width Detection ON, change the Media Detailed Settings information for thatpaper and use the regular feeding method.2. Keeping the right edge of the sheet aligned with the extended line of the paper alignment line (a)on the right side of the printer, load the sheet so that the near edge is aligned with the groove (b)at the far end of the platen.3. Check the position of the loaded paper and press the OK button.4. After a menu for selection of the paper size is shown on the Display Screen, press ▲ or ▼ toselect the paper size, and then press the OK button.Note• If a print job received requires paper larger than the selected paper, it may soil the Platen.138 Handling Paper
