Chapter 5᤹5-42 ADJUST > HVFSThis mode will prove effective when correcting image distortion under each item in question.T-5-28SPS21 Effective in special paper 2 mode and, in addition, when copying on aonesided copy.SPS22 Effective in special paper 2 mode and, in addition, when copying onthe 2nd side of a twosided copy.SPS31 Effective in special paper 3 mode and, in addition, when copying on aonesided copy or on the 1st side of a twosided copy.SPS32 In special paper 3 mode and, in addition, when copying on the 2nd sideof a twosided copy.ADJUST > HVFSSub item DescriptionSettings range: 5 to +5᤹ Standard: 0᤹ unit: 25 uARecord any new values on the service data sheet(excluding BODY (ºC), BODY (%), BODY (g), ZONE A/B/C, STMTMD and << ZONEA >>)BODY (ºC)BODY (%)BODY (g)Indicates the machine internal temperature (ºC), internal humidity (%),internal humidity absolute value (g) measured by the environmentsensor.Same as the reading under 'DISPLAY > ANALOG'FSOFST Adjusts the transfer highvoltage output.ZONE A/B/C Indicates the machine internal humidity absolute value (g) in the threeranges of A through C.STMTMD Adjust the highvoltage output for size of STMT.Setting range: 1 to +9᤹ Standard: 0If stray toner occurs for STMT size images before fixing, increase thesetting (so that the highvoltage output will increase) to limit theproblem.However, keep in mind that too high a setting will cause the paper tostick to the guide before fixing, turning into a jam.<< ZONE A >> Indicates the zone in which the setting shown is effective.ADJUST > HVSPSub item Description
