Chapter 22-202.5 Image Formation System2.5.1 Adjusting the Tensionon the Drive Belt of theTransfer Belt Motor 0002-4273CLC5100 / CLC40001) Make adjustments so that the gap of the adjustingscrew [1] of the transfer belt motor is 3.5 ±0.3 mm.F-2-382.5.2 Adjusting thePosition of the TransferBeltRelated Solenoid 0002-5740CLC5100 / CLC4000a. Adjusting the Position of the Transfer BladeSolenoid (SL7)Fix the solenoid in place so that the distance betweenthe solenoid arm and the solenoid mount base is 17.8±0.3 mm when the plunger of the solenoid is pulled.᤹F-2-39᤹b. Adjusting the Position of the Oil Removing RollerSolenoid (SL18)Fix the solenoid in place so that the stroke indicated inthe following Figure is 2.5 ±0.3 mm when thesolenoid arm is pulled by the spring.᤹F-2-402.5.3 Adjusting the Heightof the Charging Wire 0002-5765CLC5100 / CLC4000T-2-2[1]3.5±0.3mm17.8 0.3mmChargingassembly Height of charging wire (mm) VariablewidthPrimarychargingassembly4 mm(approx.)Separationchargingassembly4 mm(approx.)Prefixingchargingassembly4 mm(approx.)2.5 0.3mm10.5±0.216.5±0.317±0.3
