Danfoss VLT FC 102 Programming Manual

Also see for VLT HVAC Drive FC 102: Operating instructions Service guide Programming guide Installation guide Installation guide

Contents

Parameter Setting NotesParameter 13-41 Logic RuleOperator 1 [1] [1] AND –Parameter 13-15 RS-FF OperandS [0][26] Logicrule 0Output fromparameter 13-41 Logic Rule Operator 1[0].Parameter 13-16 RS-FF OperandR [0][27] Logicrule 1Output fromparameter 13-41 Logic Rule Operator 1[1].Parameter 13-51 SL Controller 1Event [0][94] RSFlipflop 0Output fromparameter 13-15 RS-FF Operand S andparameter 13-16 RS-FF Operand R.Parameter 13-52 SL Controller 1Action [0] [22] Run –Parameter 13-51 SL Controller 1Event [1][27] Logicrule 1 –Parameter 13-52 SL Controller 1Action [1] [24] Stop –Table 3.19 Operators13-15 RS-FF Operand SArray [8]Select the set input.Option: Function:[0] False[1] True[2] Running[3] In range[4] On reference[5] Torque limit[6] Current Limit[7] Out of currentrange[8] Below I low[9] Above I high[10] Out of speedrange[11] Below speedlow[12] Above speedhigh[13] Out of feedb.range[14] Below feedb.low[15] Above feedb.high[16] Thermalwarning13-15 RS-FF Operand SArray [8]Select the set input.Option: Function:[17] Mains out ofrange[18] Reversing[19] Warning[20] Alarm (trip)[21] Alarm (triplock)[22] Comparator 0[23] Comparator 1[24] Comparator 2[25] Comparator 3[26] Logic rule 0[27] Logic rule 1[28] Logic rule 2[29] Logic rule 3[30] SL Time-out 0[31] SL Time-out 1[32] SL Time-out 2[33] Digital inputDI18[34] Digital inputDI19[35] Digital inputDI27[36] Digital inputDI29[37] Digital inputDI32[38] Digital inputDI33[39] Startcommand[40] Drive stopped[41] Reset Trip[42] Auto ResetTrip[43] OK Key[44] Reset Key[45] Left Key[46] Right Key[47] Up Key[48] Down Key[50] Comparator 4[51] Comparator 5[60] Logic rule 4[61] Logic rule 5[70] SL Time-out 3[71] SL Time-out 4[72] SL Time-out 5[73] SL Time-out 6Parameter Descriptions Programming GuideM0010001 Danfoss A/S © 10/2019 All rights reserved. 1333 3